Radiolink Wireless Trainer System RC Radio Controller PPM Trainer Cord Cable for Airplane Flight Training Works with AT9S/AT9S Pro/AT10/AT10II/T8FB/T8S

Products Name: Radiolink Wireless Trainer System RC Radio Controller PPM Trainer Cord Cable for Airplane Flight Training Works with AT9S/AT9S Pro/AT10/AT10II/T8FB/T8S FAQ Q: Is RadioLink wireless trainer cable compatible with transmitters of other s A: Yes. Only if the transmitter has the trainer function and the paired receiver supports PPM signal output, then its compatible. Q: What if the trainer function cannot be activated A: After the binding of all the primary and secondary TX is done, set the trainer function from INH to OFF. Then toggle the SWH switch to set the corresponding positions to turn on and off the trainer function. Q: Why secondary TX fails to control when toggling the SWH switch after the trainer function setting is done A: 1) Make sure if the binding between the secondary TX and the RX connected to the wireless trainer cable is done with success. 2) Check if the signal output is PPM. If its RadioLink receivers (R6DS, R6DSM, R12DSM, R8SM, R8EF, R8FM) used, the PPM signal is with red led always on. For the other receivers, please refer to the corresponding user manuals. Q: Why do I have to keep holding the SWH switch when activating the trainer function A: Enter the menu of the primary TX- Basic Menu- Trainer- Mode- Change it as TRIGGER. If its RadioLink AT9S that you are using and you can’t find this option, please upload the firmware to V1.7.8 or above. Q: Can the wireless trainer cable be connected with other device A: The output voltage of wireless trainer cable is limited as 5V with the power of 200mA. So it only supports receivers and no other device possible.